V2000-c Rfid Access Control User Manual 🔔

The V2000-C RFID Access Control is a standalone, single-door system supporting card-only, PIN-only, and card+PIN authentication modes with up to 2,000 user capacity. Key features include a Wiegand 26 interface, Tamper alarms, adjustable door delay, and compatibility with 125KHz EM cards. For more detailed technical specifications, visit goldbridgesz.com www.goldbridgesz.com

Q: How do I wire a “Request to Exit” (REX) motion sensor? A: Connect the REX relay’s NO output to terminal 6 (PUSH) and COM to terminal 2 (GND). V2000-c Rfid Access Control User Manual

Below is a Feature Look based on the standard V2000-C configuration. This summarizes the key capabilities you would find in the user manual, categorized by how they are used. The V2000-C RFID Access Control is a standalone,

In this article, we will provide a comprehensive guide to the V2000-C RFID access control system, including its features, installation, configuration, and operation. We will also cover troubleshooting and maintenance tips to ensure optimal performance. Logs include: Card ID, user ID (if assigned),

⚠️ Perform a factory reset if default master code does not work (usually by shorting a reset jumper or powering on while pressing #).

To enter programming mode, you must use the Master Code. The default master code is usually 990101 or 123456. Enter/Exit Programming Mode Press * + [Master Code] + #. (The LED will turn red/flash). Press * to exit programming mode at any time. Change the Master Code

Exit Programming Mode: Press [*] or wait for the system to time out. 3. User Management

Event Log & Audit