Tronxy Xy-2 Pro Firmware Update !!hot!! Guide

This report covers the firmware update procedures for the Tronxy XY-2 Pro

1. Locate the screen firmware folder (usually named DWIN_SET or TJC_SET).
2. Copy this entire folder to an empty MicroSD card (formatted FAT32).
3. Physically access the screen's SD slot: This is not the front slot. You must remove the LCD back cover or slide the PCB out to find the MicroSD slot on the screen’s rear circuit board.
4. Insert the card into that hidden slot.
5. Power on the printer. The screen will flash blue/colors for 30 seconds, then show a "END" or "Download OK" message.
6. Power off, remove the hidden SD card, reassemble.

Most "helpful" reviews suggest ditching the official Tronxy firmware entirely in favor of community-compiled Marlin 2.0 tronxy xy-2 pro firmware update

Backup Current Settings: It is highly recommended to save your original G-code configuration. Create a .gcode file on an SD card with the commands M6046, M8512 "current_config", M17, and M8500, then "print" it to save your current settings to the card. 2. Official Firmware Update This report covers the firmware update procedures for

Download correct firmware – Only from: Locate the screen firmware folder (usually named DWIN_SET

Step 2: Source the correct firmware

Last tip: Before updating, connect via USB to Pronterface and send M503 – save the output. It’s your only lifeline to restore settings.

Official "Parameter Firmware" (V2.0) is available for both the standard and Titan extruder versions. www.tronxy3d.com Tronxy XY2 Pro Z Offset Fix