Programming Software Top [work]: Hyt Tc700

The primary programming software for the HYT TC-700 analog portable radio is the HT700E Programming Software

• VHF/UHF channel programming
• CTCSS/DCS tones
• 2-Tone/5-Tone signaling
• Scan lists & priority scan
• Power level (High/Low)
• Bandwidth (25kHz/12.5kHz)

Pro Tip: Always perform a "Save As" on the original code plug before making changes. Name it factory_backup.hy so you can revert if necessary. hyt tc700 programming software top

• Receive Frequency: e.g., 462.5625 (FRS/GMRS)
• Transmit Frequency: Same if using simplex; different if using a repeater (Offset).
• QT/DQT Encode/Decode: Leave blank for carrier squelch, or enter a CTCSS tone (e.g., 67.0Hz).
• Power Level: H (High - 5W) or L (Low - 1W).
• Bandwidth: 25.0K (Wide) or 12.5K (Narrow). Use narrow for modern commercial licenses.

The software was written in an era of Windows XP and serial ports. The primary programming software for the HYT TC-700

Write to radio

1. Verify settings in CPS.
2. Click “Write” (or Write to Radio).
3. Wait for completion; do not disconnect cable or power off during write.
4. Turn radio off and on to verify settings applied.

Disclaimer: Programming radios requires a valid FCC license (in the US) or appropriate licensing for the frequencies used. Operating on unauthorized frequencies is illegal and can interfere with critical public safety communications. Pro Tip: Always perform a "Save As" on

Verdict: The only top solution is the official HYT TC700 CPS.

1. Voice Operated Transmit (VOX)

Under Accessory Settings, enable VOX and set the sensitivity level (0-10). This allows hands-free operation with a compatible headset—perfect for driving or heavy machinery operation.