Ericsson Mini Link Cli Commands [extra Quality] Now
Report: Ericsson MINI-LINK CLI Commands
1. Introduction
Ericsson MINI-LINK products are microwave transmission systems used for mobile backhaul, enterprise networks, and public safety. The Command Line Interface (CLI) – often called the Craft Terminal – allows direct configuration, monitoring, fault finding, and software handling of MINI-LINK nodes without a GUI-based Network Management System (NMS).
show performance-management: Accesses historical data for Bit Error Rate (BER) and availability. ericsson mini link cli commands
SET USER PWD=<OLD_PASSWORD>, NEWPWD=<NEW_PASSWORD>
15-min and 24-hour statistics: BER, unavailable seconds, RSL
show radio adaptive-modulation 1
4. Verifying Modem Performance
While RSL tells you the power, the modem status tells you the quality. You need to know the Current Modulation (MOD) and the Signal-to-Noise Ratio. Report: Ericsson MINI-LINK CLI Commands 1
15. Best Practices & Warnings
- Always save:
copy running-config startup-configbefore reboot. - Use SSH, not Telnet, for production.
- Do not change frequency or TX power without coordination – may cause interference.
- Keep a local console cable for emergency access (management IP loss).
- Limit debug commands in live network – can overload CPU.
- Use SNMP traps for proactive monitoring instead of polling CLI.
6. Conclusion
The Ericsson MINI-LINK CLI provides comprehensive control for microwave link deployment. Key areas include radio configuration, Ethernet switching, synchronization, and fault management. Operators should focus on show radio link, show interfaces, and show alarms for daily monitoring. Configuration changes require the commit model on newer platforms. 15-min and 24-hour statistics: BER, unavailable seconds, RSL
9. Common Troubleshooting Workflow
Here is a typical workflow for a transmission engineer troubleshooting a MINI-LINK alarm: