Dp Dual Trac 20 Assembly Instructions Full _verified_ May 2026

The DP Fit for Life Dual Trac 20 (model #15-7000) is a vintage dual-action exercise bike that allows for simultaneous upper and lower body workouts. Because it is an older model, finding a complete original PDF can be difficult, but assembly typically involves four core sections: the base, the main frame/upright, the handlebar system, and the seating/pedal components. Required Tools To assemble this unit, you will typically need:

Rubber Mallet: Useful for seating plastic end caps without damaging the metal. dp dual trac 20 assembly instructions full

For replacement parts like specific cable assemblies, Fitness Repair Parts lists various lengths (e.g., 90-inch or 227-inch) that are compatible with the Fit For Life Dual Trac 20 series. The DP Fit for Life Dual Trac 20

Before you begin, clear a flat area where the machine will permanently sit, as it’s difficult to move once fully assembled. Gather the following tools: Unpacking : Carefully unpack the device and verify

: Ensure the pin holes on the plates are facing forward and the selector rod can slide through them easily.

Leveling: Ensure the unit is on a level surface to prevent uneven wear on the bushings.

Bench Mounting: The incline bench usually attaches via spring-loaded pins for easy removal or adjustment.

1. Unpacking: Carefully unpack the device and verify all components are included.
2. Base Assembly: Start by assembling the base of the device, ensuring all parts (screws, bolts, etc.) are securely fastened.
3. Main Component Installation: Proceed to install the main components (e.g., electronic parts, motors, etc.), following the diagram provided.
4. Wiring and Cabling: Carefully route and connect wires and cables as per the color codes and markings.
5. Final Check: Double-check all connections and parts for secure assembly.