Dell D220p 01 Power Supply Pinout 2 May 2026

This guide is intended for electronics hobbyists, repair technicians, and PC builders who wish to repurpose this specific power supply or troubleshoot it outside of a Dell OptiPlex chassis.

Note on "Pinout 2": Many online threads reference a second revision of this PSU where pin 18 (normally -5V in standard ATX) is repurposed for a "PS_ON" sense line or a soft-power control signal. The "2" also sometimes refers to the secondary 4-pin connector pinout (often mistaken for P4 but actually proprietary).

Turning it On: To enable the 12V output without a Dell system, you typically need to jumper Pin 5 (Remote) to Ground. Users often report the LED turning from orange (standby) to green (active) once properly shorted. Dell D220p 01 Power Supply Pinout 2

Whirrrrr.

Dell D220P-01 (part of the DA-2 series) is a 216W external power brick providing 12V at 18A. It uses a proprietary 8-pin connector that is mechanically similar to an 8-pin EPS/PCIe connector but has a completely different and incompatible electrical pinout. CPU Medics Connector Pinout Specifications The following pinout is for the female receptacle This guide is intended for electronics hobbyists, repair

Dell D220P-01 Power Supply Pinout Guide | Electrical Connector

Total combined power: 200W max. Do not exceed 12A on the 12V rail if other rails are heavily loaded. Turning it On: To enable the 12V output

The fan inside the beige brick shuddered to life. It wasn't the smooth whisper of modern cooling; it was a heavy, authoritative wind. A small LED on the circuit board flickered green. The 'Power Good' signal had been sent.