Autocraft Battery Charger Ac-60cr Manual !new! May 2026

This write-up covers the Autocraft AC-60CR (12V 60A/2A) Automatic Battery Charger and Maintainer

The Autocraft AC-60CR is a manual battery charger and engine starter designed for 12V lead-acid batteries. Unlike fully automatic "smart" chargers, manual models like the AC-60CR require the user to monitor the charging process and manually disconnect the unit once the battery is full to prevent overcharging. Quick Setup & Basic Operation autocraft battery charger ac-60cr manual

Maintenance and Troubleshooting

5. Error Codes (Real – from AC-60CR and similar AutoCraft models)

| Code | Meaning | Likely cause | |------|----------------------------------|-----------------------------------------------| | F01 | Reverse polarity | Clamps swapped. Redo connection. | | F02 | Bad battery / sulfated | Battery voltage won’t rise (>20 min in desulf)| | F03 | Short circuit (battery or clamps)| Clamps touching, or battery internal short | | F04 | Over‑temperature (internal) | Charger overheated. Let cool 30 min. | | F05 | Over‑voltage protection | Battery >15V (12V mode) or >7.5V (6V mode) | This write-up covers the Autocraft AC-60CR (12V 60A/2A)

1. ON/OFF Switch: Controls the main power to the unit.
2. Volt Selector Switch: Toggles between 6V (for vintage vehicles/lawn equipment) and 12V (for modern cars).
3. Charge Rate Switch: Selects the amperage.

   Clean Terminals: Remove any corrosion from the battery terminals before attaching clamps. Connect Clamps: ON/OFF Switch: Controls the main power to the unit

   Often includes protections against short circuits, overcharging, and reverse polarity. Maintainer/Trickle: