Arduino Sensor Shield V5 0 Manual May 2026
Arduino Sensor Shield V5.0: User Manual & Technical Write-up
1. Introduction
The Arduino Sensor Shield V5.0 is an expansion board designed to simplify connections between Arduino (Uno R3, Leonardo, or compatible boards) and various sensors, servos, and communication modules. Instead of messy breadboard jumper wires, this shield provides labeled, standardized interfaces (3-pin, 4-pin, I2C, Serial, etc.).
// Sweep back for (pos = 180; pos >= 0; pos--) myservo.write(pos); delay(15); int distance = readUltrasonic(); Serial.print("Angle: "); Serial.print(pos); Serial.print(" cm: "); Serial.println(distance);pins for every Arduino I/O, eliminating the need for breadboards and messy wiring. Electronics Katrangi Trading Key Interfaces and Pinout arduino sensor shield v5 0 manual
Zone 2: The Digital Section (Right Side - Yellow Area)
- Pins: D0 through D13.
- Format: GND – VCC – Signal (except for D0/D1 which are used for Serial).
- Special Notes:
The shield organizes pins into specialized blocks, allowing for "plug and play" connectivity without a breadboard. Arduino Sensor Shield V5
Safety & Reset: Features a remote reset button for easier access when the shield is stacked. Power Configuration (The SEL Jumper) Pins: D0 through D13
Part 1: What is the Arduino Sensor Shield V5.0?
The Sensor Shield V5.0 is a passive expansion board designed specifically for the Arduino Uno R3 (as well as the Arduino Leonardo and similar form factors). It sits directly on top of your Arduino, stacking via the standard headers.
3. Pinout Architecture and Layout
The shield functions as a "pass-through" expansion board. It does not process signals but rather reroutes the Arduino's pins to more accessible headers.